Digital Evolution System

 

ImagineElf 3D

 

 


 

       

Hole
Adding the hole.
 

  1. Run Rhino function Open (in the Rhino toolbar on the top of viewports), and open example 09_IE3D_ManShoe_Stitch.3dm.

  2. Run ImagineElf3D function Open (in the ImagineElf3D toolbar) to enter into ImagineElf3D design environment.

  3. Run ImagineElf3D function Hole new
    3.1 Selec panel(Eyelet) to add stitch in the Perspective viewport.

    3.2 Pick option .

ImagineElf3D ManShoe-Hole

3.3 According to prompt , it selects sketch in the Perspective viewport to add hole in the panel.

3.4 Pick option to set start and end position of holes in panel. If setting is ok, press Enter key to compute and exit this function.

3.5 Fig1. is computing result, it must turn on ManShoe_Panel layer to see panel with holes(see Fig2.).

  1. Run ImagineElf3D functionHole new or press Rhight mouse button in Perspective viewport to repeat the pervious command.
    4.1 Selec panel(Counter) in Perspective viewport.

    4.2 Because of Panel(Counter) is no thickness so it needs to select 2nd panel which also has no thickness, the holes will be created between to these two panel.

    4.3 Finishing to select panels, pick option , it only shows panels whit holes in the Perspective viewport.

    4.4 Pick option to select reference panel with holes. if selecting is ok, press Enter key to next step.
    4.5 Pick option to select reference hole group(see Fig.3 yellow holes are selected). if selecting is ok, press Enter key to compute(Fig.4 is result) .

  2. It can repeat Step4 or Step3 to add other panel's holes..